Проект нормативного документа.
Редакция 1.

Измерители показателей ошибок и параметров дрожания и дрейфа фазы цифровых трактов.
Технические требования.
Введен в действие Приказом Минсвязи России от 4.04.2003 № 34.

Документ утвержден приказом Минсвязи РФ от 10.08.96 №92.

Измерители показателей ошибок в цифровых каналах и трактах передачи.
Технические требования. Методы испытаний.
Введен в действие информационным письмом Министерства связи Российской Федерации от 16.12.1996 №5862.

Physical/electrical characteristics of hierarchical digital interfaces.
Corrigendum 1.

Нормы качественных показателей при вводе в эксплуатацию и техническом обслуживании международных трактов и соединений PDH многих операторов.

Error performance of an international digital connection operating at a bit rate below the primary rate and forming part of an Integrated Services Digital Network

End-to-end error performance parameters and objectives for international, constant bit-rate digital paths and connections

Bringing into service international multi-operator paths, sections and transmission systems

International multi-operator paths, sections and transmission systems fault detection and localization procedures

General requirements for instrumentation for performance measurements on digital transmission equipment.
Corrigendum 1.

Error performance measuring equipment operating at the primary rate and above.
Corrigendum 1.

Physical/electrical characteristics of hierarchical digital interfaces.

Характеристики функциональных блоков оборудования плезиохронной цифровой иерархии (PDН)

The control of jitter and wander within digital networks which are based on the 2048 kbit/s hierarchy

Synchronous frame structures used at 1544, 6312, 2048, 8448 and 44 736 kbit/s hierarchical levels.

Loss of Signal (LOS), Alarm Indication Signal (AIS) and Remote Defect Indication (RDI) defect detection and clearance criteria for PDH signals

Bringing-into-service of internationale PDH paths, section and transmission systems and SDH paths and multiplex section

Timing jitter and wander measuring equipment for digital systems which are based on the plesiochronous digital hierarchy (PDH)

General requirements for instrumentation for performance measurements on digital transmission equipment

Performance limits for bringing-into-service and maintenance of internationale PDH paths, sections and transmission systems

Pulse code modulation (PCM) of voice frequencies

Protected monitoring points provided on digital transmission systems

In-service code violation monitors for digital systems

Controlled slip rate objectives on an international digital connection

Error performance measuring equipment operating at the primary rate and above

Error performance measuring equipment for bit rates of 64 kbit/s and N*64 kbit/s

Equipment to perform in-service monitoring on 2048, 8448, 34368 and 139264 kbit/s signals

Frame alignment and cyclic redundansy check (CRC) procedures relating to basic frame structures defined in recommendation G.704

Implementor's guide for recommendation G.712

Transmission performance characteristics of pulse code modulation channels.